FOR MORE INFORMATION AND TO BUY ONLINE
CLICK HERE
Suitable for INTERNAL & EXTERNAL. A completely natural, matt finish for travertine, limestone, terracotta, quarry tiles, slate, sandstone, marble, concrete, brick and external paving. Delicately enhances colour and texture. Helps protect against staining. Strongly repels water, oil and grease. Allows surface to breath.
Coverage: From 5 - 12 sq m depending upon surface porosity
Instructions:
Important: - Matt Finish Sealer may need to be used in conjunction with a surface sealer on more absorbent, rough surface floors.
Directions: Shake the bottle prior to use. Ensure surface to be treated is completely clean, dry and free from cement and grout stain (see Grout Stain Remover). Apply 2-3 coats of Matt Finish Sealer with a paint brush, roller or sponge, allowing at least four hours between coats. More absorbent floors may require further coats and on such floors the product should be generously applied. 1-2 hours after the last application, rub over the floor with a soft fluff free cloth to obtain a uniform finish and remove any material not yet absorbed. Matt Finish Sealer will dry after about two hours, but will take a further three days to become fully resistant. N.B. Mattstone will help to inhibit oil-based stains but such spillages should be wiped up immediately.
Coverage:
Lower porosity floors Approximately 1-2 litres per 10m2 of floor Higher porosity floors Approximately 3-4 litres per 10m2 of floor
Attention:
Keep out of reach of children Use gloves to apply Avoid contact with eyes and skin In case of contact with eyes rinse immediately with plenty of water and seek medical advice In case of swallowing seek medical advice After contact with skin, wash with soap and water.
Maintenance:
Routinely sweep the floor and wash with Stonefix Maintenance Liquid. Ensure that areas where the seal has been worn or damaged are resealed with Matt Finsih Sealer. Apply a fresh coat of Sealer to your floor should it begin to shows signs of stain absorption. This should be done after the floor has been washed and allowed to dry thoroughly.
This information is offered without guarantee. The material should be used so as to take account of the local conditions and the surfaces to be treated. In case of doubt, the product should be tried out in an inconspicuous area.
