Flexible fibre rein forced compound for setting underfloor heating cables in. X Plan protects cables when tiling, levels any uneven substrates as well as reducing the amount of adhesive required for tiling.
Characteristics
? Self-Levelling
? Quick-Hardening
? Abrasive-Resistant
? For Wooden-Based Substrates
? For Heated Floors
? For Manual or Mechanical Application
? For Indoor Use
? Can be Walked on After 3-5 hrs
? Next Works After 6-12 hrs
Use
Mira X-Plan is applicable for preparing of even and smooth under-floor layer; it can be applied on concrete substrate, old tile floor, wooden-based substrates, painted surfaces, in apartments, offices, hospitals, schools, supermarkets, stores, etc. Also used for covering of floor heating cables, preparation of sloped floors. Its advantages are versatility and applicability for quick works. Hardened surface can be covered with any type of facing or lining e.g. ceramic tiles, carpet or vinyl lining, parquet, cork etc. Floor with light traffic can be painted, as the final treatment.
Substrate preparation
The substrate must be stable, dry, compact, cleaned of dust, grease, oil etc. Concrete slurry (if any) should be removed, weaker parts of substrate should be removed and then repaired again. Substrate defects shall be repaired with 6950 expres. Grease, oil, dirt should be removed with 7110 base cleaner. The entire surface should be clean of dust. A concrete substrate should be primed with mira 4180 primer thinned with water.
Thinning Ratio:
1 part of 4180 primer and 1-3 parts of water, depending on absorptivity of the substrate. Non-absorptive substrate should be primed with non-diluted 4180 primer and then powdered with x-plan, which must be rubbed into freshly spread 4180 primer. Wooden-based substrate should be primed with non-diluted 4180 primer. Drying time 1-2 hours. Do not leave any puddle. The primer improves adherence, prevents air bubbles and de-watering of mortar. If more than one layer is laid, each layer must be primed.
Technical conditions:
a. Mixing X-plan should be mixed in proportion: approx. 4,5 l of water for 25 kg of dry x-plan. Mix for approx. 2 minutes with a slow-rotating mixer or in a pump mixer,then the mortar is ready to use. Mortar for slopes should be mixed in proportion 4 l of water for 25 kg of dry x-plan.
